DIAPHRAGM WALL CONSTRUCTION

DIAPHRAGM WALL CONSTRUCTION STAGES 


A diaphragm wall is constructed in following stages :

Stage 1 : Construction of Guide Wall

Guide walls shall be constructed prior to main slurry trenching operation.

Guide walls shall be 100 to 250 mm thick 1 to 2 m deep and made of lightly reinforced concrete, and shall represent the reference lines. 


In soft ground or fill, guide walls may be taken deeper. 

When ground water table is close to surface guide walls higher than the surface level shall be constructed to maintain additional slurry head.

The clearance between finished diaphragm wall and guide may be 50 mm minimum for straight panels. 

The clearance shall be suitably increased when the panels are curved.

The finished faces of the guide walls towards the trench shall be vertical. 

Guide walls after construction should be suitably propped to maintain specified tolerance.

Mesh or cage reinforcement shall be used in guide walls. 

The level of bentonite slurry in the trench shall be 1 m or more, if necessary, higher than the ground water table.

For heavy machinery guide walls shall be constructed with suitable ground slab (on both sides of the walls).

Guide walls get support from adjoining panels and, therefore, their construction should be done continuously.

Stage 2 : Excavation of Trench Panel

Excavation of each trench panel shall be done with the help of suitable machinery. 

The trench panel shall be kept filled with bentonite slurry of suitable consistency and viscosity during the excavation period. 

Stage 3 : Installation of Stop End Tubes

A stop end tube with a smooth surface, or a structural section shall be inserted in the trench at the end of the panel to support concrete and to form a suitable joint with the next panels. 


Stage 4 : Lowering of Reinforcement cage

Reinforcement cage shall then be lowered in the trench panel and suitably supported.


Stage 5 : Placing of Concrete 

The concrete cover for the reinforcement shall be maintained by the use of spacers. Boxes or inserts for formation of recesses or for ground anchors shall be lowered along with the case to correct position and levels.

Before placing concrete in the panel the trench shall be flushed properly to clean the bottom and to remove thicker suspension from the lower level.

Stage 6 : Removal Of Stop End Tubes

The stop end tube shall be taken out gradually after initial set of concrete. This may be done carefully with the help of a suitable crane or any other lifting device.

Stage 7 : Successive Panel Construction

Form tube is generally used for creating a joint between primary and secondary panels. 

In some cases, semicircular chisels are used instead of form tubes.

Comments

READ ARTICLES:

VARIOUS METHODS FOR SEDIMENT CONTROL IN ALLUVIAL RIVER

What is the Importance of Geometric Design of Highway?

WHAT IS LINEAR PROGRAMMING? | ADVANTAGES AND LIMITATIONS OF LP | APPLICATIONS OF LP

LINEAR PROGRAMMING - GRAPHICAL METHOD, SIMPLEX METHOD AND BIG-M METHOD

GROUND WATER HYDROLOGY NUMERICALS | HYDROLOGY AND WATER RESOURCES ENGINEERING